sp = Single Primary ds = Dual Slave cs = Cable Select so set it to SP and put it on a secondary IDE controller and that should do the trick. Ron W. ----- Original Message ----- From: "Jeff Hallgren" <jhallgren at abaton.com> To: <tclug-list at mn-linux.org> Sent: Friday, August 11, 2000 4:34 PM Subject: Re: [TCLUG:20355] have disk with win95 > Brian wrote: > > > > >Guess not, the win95 disk gets detected first and screws >everything up. > > >Is this possible to do? > > >Help appreciated, > > >Jeff > > > > With Windows being as possesive as it is, I think it demands to be master on > > your system. Which port did you plug it into? > > > Not sure, I thought I was adding it downstream from the original drive > but I really don't know what "port" that is. > > > > > If you try to make it > > primary slave, Windows will rebel. Making it Secondary master should be ok. > > > If I could get www.quantum.com to work rather than give me some bizarre > error, I could probably figure out how to set the jumpers on the drive. > There are 3 postions, labeled > sp > ds > cs (jumpered) > > Its a quantum ProDrive LPS 240MB, (ha ha ha 240MB... its quite old) > > > Also, you'll have to do the LILO config yourself to see the boot sector of > > hdc (your windows drive, secondary slave). I've added partitions in LILO a > > hundred times and every single time I have to dig out the docs. Should be > > in the LILO HOWTO. > > > Yup, LILO's not too hard though. > > --------------------------------------------------------------------- > To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org > For additional commands, e-mail: tclug-list-help at mn-linux.org > --------------------------------------------------------------------- To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org For additional commands, e-mail: tclug-list-help at mn-linux.org