Okay, looks like I'll be running with the cover off for awhile... I'm going to try the "other IDE" port and set the drive to SP, I'll report back when and if I can ever reboot to linux again. Thanks. Jeff Brian wrote: > > > Not sure, I thought I was adding it downstream from the >original drive > >but I really don't know what "port" that is. > > That would be primary slave. There should be two IDE prts on your > controller/motherboard/wherever the other drive plugs into. The current > drive is primary master, the other IDE port would be secondary. set the > jumper to cs and plug it into the second IDE port. That will make it HDC. > > Sounds like you've got the rest covered, good luck to ya! Magician wrote: > > sp = Single Primary > ds = Dual Slave > cs = Cable Select > > so set it to SP and put it on a secondary IDE controller and that should do > the trick. > > Ron W. --------------------------------------------------------------------- To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org For additional commands, e-mail: tclug-list-help at mn-linux.org