I have a Compaq (I know, I know. It wasn't my choice!) Proliant ML-370 server with an ICP Vortex GDT60518RS RAID controller installed, connected to 5 9GB drives. I am trying to install Red Hat 6.2 on this machine, using the ICP Vortex controller's BIOS to set up a RAID 5 array, using 4 of the drives, and one drive as a hot spare. The logic here is that Linux should see this array as one large disk, with all the RAID minutiae handled from the Vortex card. When setting up Red Hat 6.2, I can use the expert mode to detect the RAID controller, and install goes fine. However, the machine will only boot from the boot floppy. Does anyone have experience with a similar setup? Any pointers to help me boot this machine from LILO instead of a floppy would be great. Thanks! -- Chuck Milam chuck at milams.net --------------------------------------------------------------------- To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org For additional commands, e-mail: tclug-list-help at mn-linux.org