What is the chip version (it will be 1.0, 2.0, 4.0, or 4.1)? I know for sure that the first two versions work - and I am 90% certain the latter two do (I saw the chip, Macronix in the tulip.c source code a couple months back). I know for sure the latter two versions work with FreeBSD as the dc driver - which is a tulip based driver. Chances are you have somehow loaded an incorrect module and it is not working - but it is using the resources. I think the de4x5 driver might load for some tulip based cards - but not work very well if at all (The old 10baseT Asante cards would work with either driver). Perhaps you could look through you logs (or use dmesg) to see if any other driver has been loaded. I believe the version 1.0 and version 2.0 cards will show up as "Lite-On 82c168 PNIC" and "Lite-On PNIC-II" cards respectively. The version 4.0 and 4.1 cards will show up as "ADMtek Comet" cards. I am not 100% sure about which version is which card - but it should be close. My version 2 card shows up as : "Linux Tulip driver version 0.9.10 (September 6, 2000)" "eth0: Lite-On PNIC-II rev 37 at 0xdc00, xx:xx:xx:xx:xx:xx, IRQ 11." (changed the MAC :) This is from the 2.4.0-test10 kernel - but it works fine with all kernels back to 2.2.14. Tom Veldhouse veldy at veldy.net ----- Original Message ----- From: "Yaron" <jethro at freakzilla.com> To: <tclug-list at mn-linux.org> Sent: Thursday, November 09, 2000 9:13 AM Subject: Re: [TCLUG:23602] Linksys thing > Hi, > > On Thu, 9 Nov 2000, Thomas T. Veldhouse wrote: > > > Which card is that? I believe all the Linksys PCI (10/100TX up to version > > 4.1) cards are now supported by the tulip driver. As of kernel 2.2.14. > > That's what it is, (LNE100TX), but compiling tulip into the kernel had no > impact. Compiling it as a module and trying to modprobe/insmod it said > "Device or resource busy". > > Compiling the source they provided produced two modules - tulip.o and > pci-scan.o. tulip.o requires the other module be insmodded first. I > might've missed making that one in the kernel... anyone know where that > is? > > It doesn't really matter since this is on my wife's machine, so it doesn't > get the kernel updated as often. > > -Yaron > > -- > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: tclug-list-unsubscribe at mn-linux.org > For additional commands, e-mail: tclug-list-help at mn-linux.org > >