go to ftp://sunsite.unc.edu/pub/Linux/distributions/ and into either the coyote/ or coyotelinux/ directory. There is source in there, including the kernel they use, and the config they used. Add pcmcia support to it, recompile it, and you should be able to drop it into you coyote/ tree and replace the one that sits there. When you build your floppy, it will copy your new kernel onto the floppy. Although, depending on what kind of cards you have, you may not need pcmcia support. Isn't that primarily for hot swapping cards? I've used standard kernel drivers for pcmcia ethernet cards before and they've worked fine. If you have cards though with no corresponding module in the standard kernel distrib, you'll obviously need to add pcmcia support. Jay > -----Original Message----- > From: Chris Schumann [mailto:cschumann at twp-llc.com] > Sent: Tuesday, November 28, 2000 7:54 AM > To: tclug-list at lists.real-time.com > Subject: [TCLUG] Coyote Linux on laptop, anyone? > > > I'd like to run Coyote Linux, but why use a full box with > a 250W power supply (that probably consumes 600W), when I > can use this laptop with an 18W? > > I've got a laptop with a slightly damaged screen, but it's > got two PC Card slots, and I've got two 10Mbps NICs I can > use (IBM Home & Away), but I'd need a kernel with PC Card > and H&A support as well. > > Do any of you know of places to find such info? > > Thanks, > Chris Schumann > > > _______________________________________________ > tclug-list mailing list > tclug-list at lists.real-time.com > https://mailman.real-time.com/mailman/listinfo/tclug-list >