I have a question on modem detection. I installed a modem on a RH7.2 system. Upon bootup, Kudzu detected the modem and configured the modem. If I do a lspci, I see the modem in the listing. How do I figure out which /dev/ttyS* it is parked on. I have going through the Linux Modem-HOWTO. I tried probing using setserial but all it tells me is that I have UART 16550A on ttyS0, ttyS1 and unknown on ttyS2 and ttyS3. Is there a file that Kudzu wrote the configuration to or when setserial is run on startup? I looked in the standard places such as serial.conf but there was no joy. -- Perry Hoekstra E-Commerce Architect Talent Software Services perry.hoekstra at talentemail.com