xdpyinfo shows the glx and dri modules being loaded. Thanks, Kent "Austad, Jay" wrote: > > Are you loading the DRI module? > > > -----Original Message----- > > From: Kent Schumacher [mailto:kent at structural-wood.com] > > Sent: Monday, January 08, 2001 10:24 AM > > To: tclug-list at mn-linux.org > > Subject: [TCLUG] XFree86 4.02 and Voodoo 3000 > > > > > > Well, since my system has been working perfectly for far too > > long, I needed > > to break something, so I decided to install XFree86 4.02. > > > > I did the source compile thing (make World, make install). > > did the Xfree86 -configure, > > pasted in some modelines from my old XF86Config file, exited > > my X-session and started > > things up, and *poof*, I was running 4.02. I ran problem > > free till last night when > > I tried Heavy Gear II, which just died. > > > > After massive searches through the net with minimal results, > > I ran across a directive to put > > in my XFree86 hosts.def file that stated I have glide. I > > remade 4.02 and then heavy gear > > would run, but terminally slowly (It takes forever to come > > up, and then every motion on > > the screen takes several seconds to render). > > > > Running glxinfo says that I have a gl system, although it > > reports rendering as 'indirect' > > which seems wrong. > > > > Does anybody have a working XFree86 4.xx with a Voodoo 3 (or > > Banshee?) and GL? > > > > Anybody know of any definitive links? Any advice???? > > > > Thanks, > > Kent > > _______________________________________________ > > tclug-list mailing list > > tclug-list at mn-linux.org > > https://mailman.mn-linux.org/mailman/listinfo/tclug-list > > > _______________________________________________ > tclug-list mailing list > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list -- Kent Schumacher Structural Wood Corporation 4000 Labore Rd. St. Paul, MN 55110 Phone: (651) 426-8111 Fax: (651) 426-6859 e-mail: kent at structural-wood.com