The thing is is that I have tried just taking the card out and it still frezes at pcmcia at boot up. ----- Original Message ----- From: Dave Sherman <dcsherman at qwest.net> To: <tclug-list at mn-linux.org> Sent: Thursday, January 11, 2001 12:30 PM Subject: Re: [TCLUG] Booting Pcmcia > I hit the same problem with RH 6.0. The card I have is a 3Com CardBus > 10/100. The solution I found was to download, compile and install the > latest PCMCIA source module. It worked fine after that. More recently, I > installed Mandrake 7.2 and my card worked fine immediately. > > Dave > > At 11:50 AM 01/11/2001 -0800, you wrote: > >I just installed Redhat 6.2 on my laptop last night. The whole instalation > >went with out a single glitch. Every thing was found, and the Lcd display > >works just fine. However when I rebooted, as the diferent modules start to > >load it pauses on starting PCMCIA, and will not continue. I've waited for > >about two or three minutes and still nothing would happen, it would just sit > >there. The only way I can get any controll back is to turn it off and then > >back on. Is there any way that this problem can be fixed, assuming that I > >may be able to find a way to get into the shell. > > > > > > > >------ http://USFamily.Net/info - Unlimited Internet - From $7.99/mo! ------ > > > >_______________________________________________ > >tclug-list mailing list > >tclug-list at mn-linux.org > >https://mailman.mn-linux.org/mailman/listinfo/tclug-list > > Dave Sherman > SoftServ Business Systems, Inc. > > "Quid quid latine dictum sit, altum viditur." > > _______________________________________________ > tclug-list mailing list > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list ------ http://USFamily.Net/info - Unlimited Internet - From $7.99/mo! ------