You probably need to run isapnp before loading the module. Basically, you use pnpdump to get an isapnp.conf file, modify it a little, and then run isapnp. Read the manpage for it, it's fairly straightforward. > -----Original Message----- > From: Rod Strumbel [mailto:RStrumbel at popp.com] > Sent: Wednesday, July 11, 2001 10:53 AM > To: 'tclug-list at mn-linux.org' > Subject: [TCLUG] Q/SMP and Ethernet Cards > > > I have installed RH Linux 7.1 on a ALR Q/SMP quad processor box. > > It is a EISA/PCI box running 4 - 133MHz processors - 256MB > RAM, and 30GB disk. > > Nothing special, but sufficient for home use as a hobby web server. > > Problem: It simply will not talk to any network cards I have > installed in it. Have tried a 3Com 3c509 (PCI) configured all > the ifconfig params, and for some reason even after > specifying interrupt 11 in the modules.conf, it is trying to > use IRQ = 0 ???? > > Picked up a cheapy NetGear EA302c (think that's the number) > which is an ISA card, plugged into the EISA ports, the > machine saw it as new hardware, but again, will not talk > through it to my network. > > Anyone heard anything about special configuration needs of > the Q/SMP devices with regards to Ehternet configuration? > > -Rod Strumbel > _______________________________________________ > tclug-list mailing list > tclug-list at mn-linux.org > https://mailman.mn-> linux.org/mailman/listinfo/tclug-list >