I have had a few problems getting it to work but I found the best way to start is by running gpilotd from the command line. You might get better error messages. You might have to kill the running daemon before you start gpilotd to get it to work. Also, I found that I had to start the sync on the palm before starting gpilotd. I have found that there's a lot of work that needs to be done, but it's pretty usable. (For what it's worth, I still can't get the evolution address conduit to work.) Dave On Thu, 2002-03-21 at 11:27, Amy Tanner wrote: > I am unable to get gnome-pilot to work with my pilot w/ serial cradle > and RH 7.2. I searched the ximian mailing list archives and see most > people can't get it to work but apparently some have. > > When I go to the control-center and click on Pilot Link, it says this > is the first time it's been run, and tries to sync. However, after > hitting sync button on my palm, Pilot Link just sits there and my > palm says it can't sync. Here's what I'm running: > > control-center-1.4.0.4-1.ximian.1 > gnome-pilot-0.1.64-ximian.1 > gnome-pilot-conduits-0.8-ximian.1 > > Note: I was able to get jpilot to work by creating a sym link for > libpisock.so.3 and installing with nodeps. I currently have jpilot > uninstalled, however, in an effort to get gnome-pilot to work. > > Anyone else have this working? > -- > Amy Tanner > amy at real-time.com > _______________________________________________ > Twin Cities Linux Users Group Mailing List - Minneapolis/St. Paul, Minnesota > http://www.mn-linux.org > tclug-list at mn-linux.org > https://mailman.mn-linux.org/mailman/listinfo/tclug-list > -- "They that can give up essential liberty to obtain a little temporary safety deserve neither liberty nor safety." -- Benjamin Franklin