Heck yes! We are experimenting with a unit at my work that does just that. Takes two inbound DSL or cable connections and allows you to load balance between the two. In theory. We haven't had a lot of time for testing, so I'm not sure how good it is at load balancing. I can't remember the name of the unit, but I'll write myself a note and post tomorrow with the name and model of the unit. Todd Doug Coats wrote: > I have an interesting twist that is going to be introduced to my network > here in the next month and I would like your opinion as to how to approach > it. > > We currantly have an Internet connection through Comcast (cable). I then > route this to two subnets and one webserver. We have been forced (no DSL in > our area) to have our mailserver off site hooked up to DSL so that we could > have a static IP. > > This going to change in May because we will have DSL on-site. We will be > movig our mailserver so that everything is in one building. We are planning > on keeping the Comcast connection (it's faster) and I need to incorporate > this new DSL connection into our exiting network so that we have outside > access and so that in-house mail traffic stays in-house. > > I hope that I have explained that well enough. Does anyone here have > experience in anything similar? Anyone with a gateway with two out-side > NIC's in it? Any suggestions or ideas would be greatly appreciated. > > Doug > > > _______________________________________________ > TCLUG Mailing List - Minneapolis/St. Paul, Minnesota > http://www.mn-linux.org tclug-list at mn-linux.org > https://mailman.real-time.com/mailman/listinfo/tclug-list > -- Todd Young 7079 Dawn Ave. E. Inver Grove Heights, MN 55076 _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota http://www.mn-linux.org tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list