I'm trying to upgrade and RH 9 machine to FC 2 and having troubles with my Adaptec 2410SA raid card. Looks like it's there, but I can't mount it. This chunk from dmesg shows that the system recognizes the card ... ---snip--- SCSI subsystem initialized Red Hat/Adaptec aacraid driver (1.1.2-lk2 Aug 16 2004) PCI: Found IRQ 5 for device 0000:00:0d.0 PCI: Sharing IRQ 5 with 0000:00:02.7 PCI: Sharing IRQ 5 with 0000:00:13.2 spurious 8259A interrupt: IRQ7. AAC0: kernel 4.1.4 build 9955 AAC0: monitor 4.1.4 build 9955 AAC0: bios 4.1.0 build 6101 AAC0: serial b81895fafaf001 scsi0 : aacraid Vendor: ADAPTEC Model: AAR-2410SA RAID5 Rev: V1.0 Type: Direct-Access ANSI SCSI revision: 02 SCSI device sda: 937493376 512-byte hdwr sectors (479997 MB) sda: Write Protect is off sda: Mode Sense: 03 00 00 00 SCSI device sda: drive cache: write through sda: sda1 sda2 sda3 Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 0 kudzu: Using deprecated /dev/sg mechanism instead of SG_IO on the actual device inserting floppy driver for 2.6.8-1.521 Floppy drive(s): fd0 is 1.44M ---snip--- With the RH 9 machine, I was able to mount the raid with an entry like this in fstab. /dev/sda2 /raid ext3 defaults 1 1 Now when I try and mount /dev/sda2, I just get 'sda2 is not a valid block device' Since the controller shows up in dmesg, I get the feeling I'm just being brain-dead and don't know how to read the imput well enough to know what device to mount. Can anyone point me towards a clue? -David _______________________________________________ TCLUG Mailing List - Minneapolis/St. Paul, Minnesota Help beta test TCLUG's potential new home: http://plone.mn-linux.org Got pictures for TCLUG? Beta test http://plone.mn-linux.org/gallery tclug-list at mn-linux.org https://mailman.real-time.com/mailman/listinfo/tclug-list