> -----Original Message----- > From: tclug-list-bounces at mn-linux.org > [mailto:tclug-list-bounces at mn-linux.org] On Behalf Of Erik Mitchell > Sent: Saturday, October 06, 2012 8:10 AM > To: TCLUG Mailing List > Subject: Re: [tclug-list] Wifi at Hennepin County Library (Edina) > > > Normally, I must get the wifi card to "connect" (ie, grab RF signal > > carrier), and then open a browser so I can say OK to yheir intended > > usage policy. > > After that, IP assigned and it's open... But not until. > > I would need to have an IP address before the browser is > going to be able to communicate with their access point > though. I'm not getting an IP address. I'm wrong about IP, then, but sequence is as described: connect at "carrier level", then do browser OK. Have not looked closely at exactly what happens when. Should be simple matter of doing as I described. Debug may be much harder. Chuck > > I'll need to try again and see if I can get some better debug > output to figure out what's happening. > > Thanks for your help. > > -Erik > -- > Erik K. Mitchell > erik.mitchell at gmail.com > _______________________________________________ > TCLUG Mailing List - Minneapolis/St. Paul, Minnesota > tclug-list at mn-linux.org > http://mailman.mn-linux.org/mailman/listinfo/tclug-list >